update 5 : 8-11-2009
here 1 can see the new coil setup in the Big Unit...much better now...:))


side view of the Big Unit...i also twist the GC wires so they look better 2 now...;-)


yep...i encounter a small problem so i had 2 make some changes like 1 can see here...:/
now me Big Rotor can slide 2 its place and b lock down in place much easier...pffffiiieeew...:P


ahhhh...sweet...Rotor in place...:D


side view with Rotor in place...
see how the bearing is locked down in place...;-))
i must say that ima really pleased with the results of the Rotor...:D
when given a small push it spin 4 a very long time...very little friction and very good momentum...:DD


update 6 : 10-11-2009
here 1 can see the 2 finished small rotors...:)
ever try 2 drill square holes...lol...haha
its been a pain BUT with some patience i got them done very nicely...:P


here 1 can see that ima have put some supports for the small units(number 1 & 2)...:)
number 1 is smaller becoz that side is perma fixed...8)
number 2 is larger becoz that side is removeble...8)
number 3(middle unit @ the top) was just a temp support 2 keep the whole unit in place...;-)


just a pic of all 3 full view...:)


update 7 : 15-11-2009
the 3 parts of the main rotor with all magnetes finally glued...:)


the big unit with the rotor inplace...:)


and all 3 units with all 3 rotors assemble...:)


Cheers & Thumbs Up 4 The Daftman